DIY Wedding Crafts

diy Wedding Crafts: Washer & Ribbon Necklace

Share on Facebook0Tweet about this on Twitter5Pin on Pinterest8Share on Google+8Share on Tumblr0Share on LinkedIn2Print this page

diy Wedding Crafts: Washer & Ribbon Necklace - get inspired at diyweddingsmag.com

This washer and ribbon necklace would be a great wedding accessory for a rustic or cowboy theme wedding. Budget friendly and an easy diy doable!

diy Wedding Crafts: Washer & Ribbon Necklace - get inspired at diyweddingsmag.com

Materials Needed:

  • 20 – 30 1″ metal washers (I used 24. Use more or less to make it the length you want.)
  • 5/8″ wide grosgrain ribbon, about 1 yard (or more, depending on your desired length of your necklace)

Instructions:

Step 1: Thread your ribbon up through washer #1, leaving enough ribbon on the end to tie the necklace when it’s finished.

Step 2: Thread the ribbon down through the top of washer #2.

Step 3: Thread the ribbon back down through washer #1.

Step 4: Pull the ribbon tight, so washer #2 is laying flat on top of washer #1.

Step 5: Thread the ribbon back up through washer #2.

Step 6: Repeat steps 2 through 5 for each additional washer. Once you’ve threaded all your washers onto the ribbon, tie the two ends of the ribbon together and trim off the excess. Finished! Easy, right?

If you loved the washer and ribbon necklace, check out Nestled’s handmade jewelry shop on Etsy.

 

Photography & Project:  Nestled

 

9 Comments

Click here to post a comment

Browse Our Site By Color



Blogher


top-100-wedding-resources-award-2016